Vertical Power Line 2+1+1 lower Poly (Residential)

Vertical Power Line 2+1+1 lower Poly (Residential)

This is a utility pole spline with wires, typical of what might be found in a residential area. This differs from the similar Vertical Power Line 3+1 in that the third wire is lower and somewhat fatter, representing a typical telco cable. The poles are of a typical height, but are able to be raised up to an additional 6 meters from the default height, enough to clear an embankment over an under-grade bridge with room to spare. These make use of the latest mesh-stitching and LoD techniques, so you can use large quantities or runs of these on your layout. The high-detail mesh weighs in at 530 polys per section (1 material) but only 58 polys per low-detail section.

Author: RRSignal

Vertical Power Line 2+1+1 lower Poly (Residential)
• config.txt 3.79KB
• pole-only-hi.im 19.82KB
• pole-only-lo.im 3.68KB
• pole-wires-hi.im 36.82KB
• pole-wires-lo.im 4.96KB
• pole.texture.txt 43 bytes
• pole.tga 2.00MB
• thumbnail.jpg 7.94KB

VE48: This asset uses an obsolete trainz-build number. Trainz-build numbers below 3.5 are no longer supported.
VE186: Material 'arc:fld:$(original)/hash-B4||kuid 481384 1414146.tzarc|**rusty.m.onetex' is shared between multiple chunks in this asset but the material parameters conflict.
VE186: Material 'arc:fld:$(original)/hash-B4||kuid 481384 1414146.tzarc|**rusty.m.onetex' is shared between multiple chunks in this asset but the material parameters conflict.
VE186: Material 'arc:fld:$(original)/hash-B4||kuid 481384 1414146.tzarc|**rusty.m.onetex' is shared between multiple chunks in this asset but the material parameters conflict.