Compensator for point rodding thermal expansion, 1x1, NSWGR

Compensator for point rodding thermal expansion, 1x1, NSWGR

A compensator that allows attached point rodding to expand and contract with temperature changes without buckling or stretching the rodding.
A compensator was normally fitted midway along a long rod run so that the thermal changes in rodding length were equal on either side of the compensator.
Intended for connection with <kuid:368725:30062> 'point rodding, 1x, NSWGR'.
Where a compensator is to be fitted to 1 rod in the 2-rod run of <kuid:368725:30063> 'point rodding, 2x, NSWGR', use compensator <kuid:368725:20399> or <kuid:368725:20400> rather than this asset.
Where a compensator is to be fitted to 1 rod within the 3-rod run of <kuid:368725:30064> 'point rodding, 3x, NSWGR', transitions must be used on either side of the compensator. Use <kuid:368725:20302> 'point rodding transition, 3x to 2x1, NSWGR'.

Author: Leigh Stokes (ElStoko)

Compensator for point rodding thermal expansion, 1x1, NSWGR
• base.im 2.82KB
• compensator-low.im 59.03KB
• compensator-med.im 88.40KB
• compensator.im 102.11KB
• config.txt 2.92KB
• crank-crank.texture.txt 45 bytes
• crank-normal-crank-normal.texture.txt 84 bytes
• crank-normal.tga 512.02KB
• crank.tga 512.04KB
• thumbnail.jpg 10.99KB